Article archive
08/12/2014 11:54
The cable buffer is one of two types:loose buffer or tight buffer.The loose buffer uses a hard plastic tube being in an inside diameter several times that of the fiber.One or more fibers lie within the buffer tube.The tube isolates the fiber from the rest of the cable and the mechanical forces...
08/01/2014 12:23
Fiber Optic Patch Cables consists of one or more glass or plastic fiber cores encased in a glass tube,called cladding.The fiber cores and cladding are surrounded by a PVC cover. Signal transmission along the inner fiber usually consists of infrared light.
There are three commonly used Fiber Optic...
07/31/2014 14:40
There are four major types of fiber connectors: Straight (ST)，straight connection (SC)，medium interface connector (MIC)，and submarine type A (SMA).General，The fiber optic patch cord is composed of a fiber optic cable terminated with different connectors on the ends.Such as the LC LC Fiber Patch...
07/30/2014 14:22
Consider that the capacity of a simple telephone line to carry data is equivalent to the flow of liquid through a drinking straw.It would take a tunnel large enough to drive a bus through to equal the bandwidth of a single fiber optic strand using today's technologies.Furthermore, if technology...
07/29/2014 12:18
Fiber optic ethernet systems are based on multimode and single mode fiber optic cables and connectors ,depending on the speed of the ethernet media system and the type and wave length of fiber optic transmitters used in the system,the behavior of fiber optic media can vary.This is especially true...
07/25/2014 11:50
Connectors and adapters are the plugs and sockets of a fiber optic system. They allow the data to be re-routed and equipment to be connected to existing systems.Connectors are intrinsically more difficult to design than mechanical splices.This is due to the added requirement of being able to be...
07/24/2014 12:24
A wide variety of connectors can be used with fiber optic media,depending on the light emitting sources used to generate light pulses and the corresponding light-detecting sensors used to detect them,Figure 4-19 shows some connectors described in the following list: SC connector,ST connector,MT-RJ...
07/18/2014 11:33
Usually the fiber patch cord is divided into single-mode fiber and multimode fiber, the Single mode optical fiber core diameter is small, only on work at a given wavelength in single mode transmission, transmission band, large transmission capacity,Among them, more widely used is the LC - LC...
07/17/2014 12:37
Four standardizedphysical implementations of Ggigabit Ethernet exist:
1000BSE-SX--A fiber optic implementation for a pair of multimode fiber.SX corresponds to short wavelength,lasers transmitting light at a wavelength of 850 nanometers are used.
1000BASE-LX--A fiberoptic implementation for a...
07/15/2014 12:28
Fiber optic cable,or simply fiber,contains one or several glass or plastic fibers at its center,or core,Data is transmitted via pulsing light sent from a laser (in the case of 1- and 10-gigabit technologies)or an LED (light emitting diode)through the central fibers.Surrounding the fibers is a layer...
Items: 1 - 10 of 19